Home > Shop by Manufacturer > MAC > MAC Prochambers >

MAC After-Cat Prochamber (11-14 V6)

MAC 11-14 Mustang V6 Weld On Prochamber PC2205

Regular Price $389.50
Sale Price $369.99
Manufacturer Part # PC2205

Availability: Usually Ships in 24 Hours
Product Code: 4660

The PC2205 is MAC's Prochamber unit that welds onto your factory mid pipe. Partial cutting of the factory mid pipe section and then welding is required for installation. If your modding on a budget, the weld-on Prochamber gives you a bump in power while retaining your factory convertors. Unlike your standard H pipe, the MAC Prochamber unit offers a free-flowing design that is significantly more efficient. The result is more horsepower and torque over any other mid pipe! Not only will you get an improvement in exhaust flow, but you'll also notice a deeper, throatier exhaust note after installation.

This version of MAC's V6 Mustang Prochamber welds onto your factory mid pipe behind the cats. Since your not removing the catalytic convertors there is no need to worry about check engine lights or re-tuning of your Mustang.

Product Specs:
  • Cut and welds to your factory mid pipe just behind the catalytic convertors
  • Constructed from 2.5" stainless steel tubing
  • Prochamber unit outflows any conventional H pipe design
  • Off road design for maximum exhaust flow and sound
  • Fits all 2011-2014 V6 Mustangs
Key Product Specs
    • Prochamber unit adds deep, aggressive tone
    • Makes your V6 sound like a V8
    • Cut and welds in place before catalytic convertors
    • Allows use of factory cats

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Shop by Manufacturer > MAC > MAC Prochambers
Exhaust > Mustang Mid-Pipes > 2011-2014 V6