Installing A Billet Aluminum Shorty Antenna On Your 2010-2013 Mustang
Even though they improved the look of the antennas on 2010 and up Mustangs by moving it to the rear quarter panel, it's still too tall and looks kinda silly on the Mustang's new sleek body. We have an affordable solution that will improve the look of the antenna while retaining radio signal and functionality. Our 4" billet aluminum antennas come with all hardware and tools needed for the installation. Install takes about 20 minutes. View our shorty antennas here: Shorty Antennas at Stangmods.com
After removing the stock antenna, use the included tool to unscrew the piece that holds the stock base to the car. Ours was too tight to remove by hand but came loose easily with a set of pliers.
Once the metal part that holds the stock base is removed, the base should come right off. You will be re-using this part to mount the new billet base so make sure not to misplace it.
Reinstall the new billet base and screw the factory metal piece in using the included tool to secure the base of the new antenna. Do not over tighten this, just enough so the base doesn't move around. Over tightening could damage your paint.
Once the base is secured, screw one end of the threaded pin into the antenna itself. Once this is tight, install the upper base piece and screw the antenna in through the base. Make sure this is tight enough that the upper part of the base does not spin freely.
That's it, all done! The install is a breeze and the shorty antenna looks much better than the factory mast. Thanks for reading! You can find this part on our store in either powdercoated black like the one shown here, brushed aluminum or chrome. This antenna will fit all 2010-2013 Mustangs.