Removing & Installing Hood Vents on 2013 Mustangs

One of the most exciting changes on the new 2013 Mustang line are the new hood vents that come standard on the V6, GT & Boss 302 Mustangs. These fully functional vents allow the engine bay to run a bit cooler which in turn improve intake temps and ultimately improve power and efficiency. Plus, they look plain awesome. Changing the vents to black or any other color is a breeze since these vents are easily removed with a deep 8mm socket and by un-clipping them from the hood. Follow along below to see how it's done in a few easy steps.

We sell the factory OEM Ford vents on our site unpainted, these are great for someone who wants to paint them a custom color themselves. You can find them here: http://www.stangmods.com/2013-Mustang-OEM-Hood-Vents-sold-in-pairs-p/2303.htm

Tools Needed:
8mm deep socket
Ratcheting socket wrench

Start by removing all of the clips holding the under-hood insulation on. Leave the bottom row attached, as you just need to remove enough to get to the bolts and clips holding the vents on.





Next, remove the 8mm nuts on the bottom of each vent. On the passenger side, remove the plastic clip holding the washer fluid line in place.



Once the nuts are removed, squeeze the clips on either side of the vents and push upwards, use your other hand to pull gently from the top side of the hood to free the vents from the hood itself. Do not use too much force, patience is key here.





Once the vents are free of all their clips, they will easily come free of the hood. Reinstalling the new vents is just the reverse of the steps above. Make sure you get all the clips snug when installing the new vents and remember to reinstall the 8mm nuts on the bottom of the vents as well as the washer line on the passenger side vent.



Here are photos of the factory painted vents and the new vents we installed (factory unpainted). In the next few weeks we will be posting new vent finishes including matte black and carbon fiber. Stay tuned!